Please login first
Enhanced pathogen detection and cell concentration using acoustophoretic deposition on surfaces
1  University of Southampton

Abstract:

There is a pressing need for simple, rapid and effective ways of concentrating and capturing bacteria and bacterial spores for detection and identification [1].  Acoustofluidic approaches can act on a large number of cells simultaneously over a relatively wide area, allowing cells to be imaged, concentrated, or captured in a flow-through system. This paper discusses the use of planar ultrasonic resonator systems for high throughput 2D cytometry, for cell concentration and finally for cell capture on functionalized surfaces.  Recent results demonstrate the capture of bacterial spores on antibody functionalized surfaces and it is shown how the same technology can be used to capture cells from more complex fluids such as whole blood. 

Acoustophoretic forces tend to move cells to regions of low acoustic pressure and within planar resonator systems [2] it is generally simplest to generate forces towards the centre of a flow-through chamber as shown in Fig. 1 (a) (a half wave resonance).  Such a half wave mode can be used for particle concentration in low aspect ratio channels [3] but in the wide channels of these resonators the fluid behaviour makes the extraction of a high concentration challenging [4].  Such a half-wave mode can successfully be used to move particles into the focal plane of an imaging system [5].  This approach not only places particles or cells at the imaging focus, but has the additional significant advantage that within a highly laminar flow, all the particles in this optical focal plane will travel through the imaging field at identical velocities, allowing particle tracking during imaging without motion blur.  This has allowed 2D imaging of beads and cells at very high throughputs – up to 200,000 beads per second [5].

A better approach to concentrating bacteria is to force them to a surface rather than to the centre of a channel.  Early acoustic designs for moving particles to a surface were very sensitive to precise layer thicknesses [6], but by using just a thin layer to form the reflector of the device so that the reflection is effectively from the low acoustic impedance air boundary, produces a more robust field [7].  Such an approach for concentrating bacteria, as shown in Fig. 1 (b), can be used to increase the concentration of E. coli by a factor of 60 and at a flow rate of 20 ml/hr [4].

This flow-through concentration requires a further identification stage but a more efficient approach is to detect bacteria of interest within the flow-through chamber itself.  This can be achieved using the approach shown schematically in Fig. 2 in which the machined stainless steel device shown in Fig. 3 incorporates a “thin reflector” that comprises a cover-slip with antibody functionalization for bacterial capture.  Fig. 4 shows an image of a slide with spots functionalized to capture Bacillus globigii (BG) spores using a spore concentration of 105 per ml and a flow rate of 10 ml/hr.  The same approach has also been used successfully to isolate Basophils from diluted whole blood.

Top