EventsThe 13th International Electronic Conference on Sensors and Applications
Published
with-doi10.3390/engproc2026163069 (registering DOI)
This submission belongs to the session S3. Sensor Networks, IoT, Smart Cities and Health Monitoring of the event The 13th International Electronic Conference on Sensors and Applications
Published date
16 Nov, 2026
Academic Editor
author-avatarFrancisco Falcone
Citation
Felipe Augusto Barnabe, Fabricio Guimaraes Baptista, Impedance-Based Damage Detection in CFRP Composites Under Uniform and Non-Uniform Temperature Distributions, in Proceedings of The 13th International Electronic Conference on Sensors and Applications, 18 November–20 November 2026, MDPI: Basel, Switzerland, doi: 10.3390/engproc2026163069
Share
Email
Facebook
Twitter
LinkedIn

Impedance-Based Damage Detection in CFRP Composites Under Uniform and Non-Uniform Temperature Distributions

image
1. Laboratory of Transducers and Data Acquisition, Department of Electrical Engineering, School of Engineering, São Paulo State University (UNESP), Bauru 17033-360, Brazil
Abstract

The electromechanical impedance (EMI) method has been extensively studied for damage detection in structural health monitoring (SHM). The method uses piezoelectric transducers to measure the electromechanical impedance and, as is well known, is highly sensitive to temperature, which alters the properties of both the monitored structure and the transducer. The effects of temperature have been extensively studied in recent years. Studies reported in the literature typically conduct experimental analyses with test specimens under uniform temperature distribution obtained using controlled chambers. However, in real-world applications where the environment is not controlled, the monitored structure may exhibit a non-uniform temperature distribution. Therefore, this paper presents a comparative experimental analysis of the impacts of uniform and non-uniform temperature distributions on the monitored structure. Tests were conducted on a carbon fiber-reinforced polymers (CFRP) plate as a test specimen under different temperature distributions. The test specimen was heated using a heat gun, and the temperature distribution was measured and controlled with a thermal camera. A piezoelectric transducer was attached to the test specimen, and the electromechanical impedance was obtained using a measurement system based on a data acquisition (DAQ) device. The effects of uniform and non-uniform temperature distributions were analyzed by observing the impedance signatures and quantified using damage indices. The results show that non-uniform temperature distribution can reduce the effectiveness of compensation techniques and hinder the correct diagnosis of the monitored structure.

Keywords
Piezoelectric transducers
impedance
temperature
distribution
SHM
Manuscript
Sciforum-192095engproc-163-00069.pdf
Mass transfer limitations in the detection of proteins that undergo conformational changes in adsorption-based microfluidic biosensors
IoT-Enabled Vision-Based Assistance System for Paralyzed Individuals with Real-Time Remote Alerts