EventsThe 13th International Electronic Conference on Sensors and Applications
Published
with-doi10.3390/engproc2026163073 (registering DOI)
This submission belongs to the session S3. Sensor Networks, IoT, Smart Cities and Health Monitoring of the event The 13th International Electronic Conference on Sensors and Applications
Published date
16 Nov, 2026
Academic Editor
author-avatarFrancisco Falcone
Citation
Alejandro Bernal, Patricia Arroyo, Ángel López, Víctor González, José Ignacio Suárez, Cristina Brugera, Eduardo Pinilla-Gil, Juan Álvaro Fernández, José Luis Herrero, Jesús Lozano, Low-Cost IoT-Based Formaldehyde Monitoring for Preventive Conservation in Museum Display Cases, in Proceedings of The 13th International Electronic Conference on Sensors and Applications, 18 November–20 November 2026, MDPI: Basel, Switzerland, doi: 10.3390/engproc2026163073
Share
Email
Facebook
Twitter
LinkedIn

Low-Cost IoT-Based Formaldehyde Monitoring for Preventive Conservation in Museum Display Cases

image
image
image
1. Industrial Engineering School, University of Extremadura, 06006 Badajoz, Spain
2. School of Engineering and Technology, International University of La Rioja, 26006 Logroño, Spain
3. Faculty of Science, University of Extremadura, 06006 Badajoz, Spain
Abstract

Introduction
Environmental monitoring in museums becomes important because it helps identify deterioration risks for cultural heritage collections. While temperature and relative humidity are usually monitored in museum display cases, volatile organic compounds (VOCs) are typically assessed using passive samplers and laboratory analysis, providing only periodic information at a high cost. However, VOCs represent a challenge for the conservation of metallic, calcareous and organic objects. Among them, formaldehyde stands out, followed by acetic acid and formic acid. This work presents the development and preliminary validation of a low-cost IoT-based detection node for continuous monitoring inside museums.
Methods
A low-power, compact wireless node has been designed using an ESP32-S3 SoC as main core. Given the importance of formaldehyde, an SFA30 digital electrochemical sensor (Sensirion) has been incorporated, capable of detecting concentrations in the ppb range. The node also incorporates temperature, relative humidity, pressure and generic VOCs (MOS type) sensors. Moreover, the Wi-Fi module enables remote data transmission, storage and visualisation. The electronics, mounted on a custom PCB, were placed inside a 3D-printed housing with passive ventilation.
The formaldehyde sensing stage was first tested under controlled laboratory conditions using known concentrations (20-500 ppb) sampled in a static headspace. Following this preliminary validation, several nodes were installed in museum display cases under real exhibition conditions.
Results
In the laboratory experiments, the SFA30 sensor readings made it possible to obtain concentrations close to those generated using known dilutions. On the other hand, continuous measurements were acquired and stored remotely on a private server. During museum deployment, the system provided uninterrupted remote data for subsequent analysis.
Conclusions
The proposed IoT node represents a low-cost approach for monitoring formaldehyde and other environmental parameters in museum display cases. The results support its potential use in preventive conservation, although further calibration and long-term validation are still required.

Keywords
low-cost sensors
formaldehyde
wireless sensor networks
cultural heritage
preventive conservation
IoT
indoor air quality
Manuscript
Sciforum-193611engproc-163-00073.pdf
Embedded Acoustic Sensing for Infant Cry Classification and Intelligent Comfort Response
Residual-Allocation Control in Color Correction Matrix Calibration via Weighted Constrained Models