EventsThe 2nd International Conference on Bioengineering
Published
This submission belongs to the session S5. Biomechanics and Sports Medicine of the event The 2nd International Conference on Bioengineering
Published date
16 Nov, 2026
Citation
Lena Malin Baeumker, Niko Nagengast, Franz Konstantin Fuss, Smart 3D-printed bouldering hold with integrated pressure sensors produced in a single manufacturing process for monitoring and optimizing the climbing process, in Proceedings of The 2nd International Conference on Bioengineering, Barcelona, 10 November–13 November 2026, MDPI: Basel, Switzerland
Share
Email
Facebook
Twitter
LinkedIn

Smart 3D-printed bouldering hold with integrated pressure sensors produced in a single manufacturing process for monitoring and optimizing the climbing process

image
1. Chair of Biomechanics, University of Bayreuth, Bayreuth, Germany
Abstract

Introduction:

Bouldering is a climbing discipline characterized by a few difficult moves. Will Bosi replicated the outdoor bouldering route "Burden of Dreams" using 3D-printed holds for indoor training and successfully climbed it after 24 days. To monitor and optimize training, holds should be instrumented to measure contact forces and durations.


Methods:

A 40 mm high hold designed for a two-finger grip, featuring a 25 x 40 mm ledge, was 3D-printed using a 5-head printer (Prusa XL Multitool). A resistive pressure sensor was 3D-printed into the hold during a single printing process, using five materials (non-conductive, support, electrode, and two sensor materials), following a prototype with separately printed components. After printing, the smart hold was calibrated using a materials testing machine (Zwick/Roell Z050) for compression testing while recording the sensor’s voltage drop via its analog port. Subsequently, the hold was tested in a bouldering scenario involving all four limbs with two participants (the authors). Force exerted on the hold was calculated using the calibration curve (polynomial fit of force vs. conductance data).


Results and Discussion:

The sensor responds rapidly to force changes. The calibration curve exhibits moderate hysteresis, causing a timing error of approximately 0.5 seconds. The measurement range caps at 500 N, where the sensor saturates, but it detects forces below 1 N at the lower end. On the climbing wall, the force on the smart hold increased during the transition from a “straight arm, bent legs” posture (20-30 N) to a “bent arm, straight legs” posture (40-100 N) as the body's center of mass was pulled upward.


Conclusions:

Based on calibration and wall-based testing, the smart hold is suitable for measuring normal force and contact time. The materials and printing costs of the hold, excluding electronics, are approximately €6.

Keywords
Bouldering
Piezoresistive Pressure Sensor
Multi-Material 3D Printing
Enhancement of Flavone Yield of Scutellaria baicalensis Hairy Root Cultures through Metabolic Engineering using AtMYB12 Transcription Factor
Classification and performance ranking of artificial intervertebral discs based on kinematics and statics