EventsThe 2nd International Online Conference on Marine Science and Engineering
Published
This submission belongs to the session S1. Ocean Engineering of the event The 2nd International Online Conference on Marine Science and Engineering
Published date
18 Nov, 2026
Academic Editor
author-avatarWeicheng Cui
Contribution&Funding
Conceptualization,
[Muhammad Sohail Ashraf]
Methodology,
[Muhammad Sohail Ashraf]
Software,
[Muhammad Sohail Ashraf]
Validation,
[Muhammad Sohail Ashraf]
Formal analysis,
[Muhammad Sohail Ashraf]
Investigation,
[Muhammad Sohail Ashraf]
Resources,
[Muhammad Sohail Ashraf]
Data curation,
[Muhammad Sohail Ashraf]
Writing - original draft,
[Muhammad Sohail Ashraf]
Writing - review,
[editing] ; [Muhammad Sohail Ashraf]
Visualization,
[Muhammad Sohail Ashraf]
Supervision,
[Muhammad Sohail Ashraf]
Project administration,
[Muhammad Sohail Ashraf]
Funding: --
Citation
Muhammad Sohail Ashraf, Abdul Hanan, Numerical Investigation of a Vertical-Axis Wind Turbine for Marine Applications, in Proceedings of The 2nd International Online Conference on Marine Science and Engineering, 23 November–25 November 2026, MDPI: Basel, Switzerland
Share
Email
Facebook
Twitter
LinkedIn

Numerical Investigation of a Vertical-Axis Wind Turbine for Marine Applications

1. Mechanical Engineering, University of Engineering and Technology, Lahore, 54920, Pakistan
Abstract

Introduction: Demand for sustainable energy has increased interest in the use of wind power for marine and shipboard applications. Among vertical-axis wind turbines, the Savonius rotor is attractive because of its omnidirectional operation, compact configuration, and suitability for auxiliary power generation on ships. This study investigates the structural integrity and dynamic behaviour of a three-stage Savonius vertical-axis wind turbine under selected offshore environmental loading.

Methods: The turbine geometry was developed in SolidWorks 2024 using a 1 m rotor diameter, 1 m overall rotor height, and a 60° phase shift between successive stages. A one-way fluid–structure interaction analysis was performed by coupling SolidWorks Flow Simulation with the structural solver. A Eurocode-based logarithmic wind profile with a reference velocity of 24 m/s was applied to the fluid domain, and the resulting aerodynamic pressure distribution was transferred to the structural model. A simplified wave-induced vertical base acceleration of 4.625 m/s² was also applied to represent shipboard inertial loading.

Results: The numerical results showed a maximum von Mises stress of 12.15 MPa at the shaft–deck junction and a maximum total deformation of 0.3353 mm at the upper free end of the shaft. Both values remained below the yield limit of the selected stainless steel. Modal analysis identified the first torsional mode at 2.3448 Hz and two bending modes at 4.7394 Hz and 4.8013 Hz. The calculated frequencies were separated from the low-frequency ship-motion range considered in this study.

Conclusions: These findings indicate that the proposed three-stage Savonius turbine has satisfactory preliminary structural performance for shipboard renewable-energy applications. Future work should include experimental validation, rotating-flow simulation, two-way fluid–structure interaction, and multi-axis vessel-motion loading.

Keywords
Vertical-Axis Wind Turbine
Savonius Rotor
Fluid–Structure Interaction
Shipboard Wind Energy
Modal Analysis
Structural Integrity
Offshore Renewable Energy
Mechanical Engineering Design Innovations for Sustainable Marine Plastic Waste Collection and Ocean Pollution Control
Dual-Objective Control of Thermoelectric Waste-Heat Recovery in Marine Raw-Water Cooling Circuits