EventsThe 2nd International Online Conference on Marine Science and Engineering
Published
This submission belongs to the session S1. Ocean Engineering of the event The 2nd International Online Conference on Marine Science and Engineering
Published date
18 Nov, 2026
Academic Editor
author-avatarWeicheng Cui
Citation
Gerome John S Cardona, Larry Jr E Vasquez, Jericho Albert G Lapinid, Ralph Kristoffer B Gallegos, Outrigger Diameter and Separation Effects on Roll, Heave, and Stability of Philippine Fishing Vessels in Beam Seas, in Proceedings of The 2nd International Online Conference on Marine Science and Engineering, 23 November–25 November 2026, MDPI: Basel, Switzerland
Share
Email
Facebook
Twitter
LinkedIn

Outrigger Diameter and Separation Effects on Roll, Heave, and Stability of Philippine Fishing Vessels in Beam Seas

image
image
1. Department of Mechanical Engineering, University of the Philippines Los Baños, College, Laguna, Philippines 4031
2. Institute of Agricultural and Biosystems Engineering, University of the Philippines Los Baños, College, Laguna, Philippines 4031
Abstract

Bangka or Philippine outrigger fishing vessels remain a primary source of livelihood and transportation across Philippine waters, yet their outrigger geometry is regulated only by local construction minimums and lacks validation against dynamic seakeeping performance. This study evaluates a hydrodynamic model of a 16m vessel in which the hull is modeled as panels and Outriggers as Morison elements, with coefficients Cm=2.0 (for cylindrical tubes) and Cd=1.2, adjusted to reflect drag-dominated flow around a rough cylinder at the study’s Reynolds and Keulegan-Carpenter numbers. The frequency range of 0.04 Hz - 1.20 Hz was used across a parametric sweep of diameter (0.15 m - 0.35 m) and separation (3.0 m - 7.0m), two levels above and below the Philippine-specific regulatory baseline (4.7 m separation rounded to 5.0 m as sweep center, 0.25 m equivalent diameter), producing 25 configurations that are tested in beam seas (90°). Because the solver linearizes Morison drag against the RMS relative fluid velocity, the resulting RAO values were computed for Hs=3.0 m (JONSWAP spectrum) rather than being independent of sea state. Results show that Peak roll RAO varied by 205.7%, from the maximum configuration (5.61 deg/m; 7.0 m separation; 0.15 m diameter) to the minimum configuration (17.15 deg/m; 3.0m separation; 0.35 m diameter). Increasing separation alone reduced peak roll RAO by 56%. Increasing diameter alone, meanwhile, increased peak roll RAO by 32-35% because both Morison inertia and drag forces scale with diameter and increase more than the restoring stiffness. Heave RAO, by contrast, varied by only 10% (0.851 m/m-0.937 m/m) across all configurations. These results show that separation is the dominant geometric parameter in reducing peak roll response, while heave is relatively insensitive to the investigated changes.  

Keywords
Philippine bangka
outrigger fishing vessels
roll and heave
Morison elements
ANSYS AQWA
Assessment of a Floating Renewable Energy Platform under Black Sea Environmental Conditions
Hydrodynamic Performance and Noise Characteristics of a Full-Scale Tidal Turbine under Different Tip Speed Ratios