EventsThe 2nd International Online Conference on Marine Science and Engineering
Published
This submission belongs to the session S1. Ocean Engineering of the event The 2nd International Online Conference on Marine Science and Engineering
Published date
18 Nov, 2026
Academic Editor
author-avatarWeicheng Cui
Citation
Linyang Zhu, Esteban Ferrer, Hydrodynamic Performance and Noise Characteristics of a Full-Scale Tidal Turbine under Different Tip Speed Ratios, in Proceedings of The 2nd International Online Conference on Marine Science and Engineering, 23 November–25 November 2026, MDPI: Basel, Switzerland
Share
Email
Facebook
Twitter
LinkedIn

Hydrodynamic Performance and Noise Characteristics of a Full-Scale Tidal Turbine under Different Tip Speed Ratios

1. School of Aeronautical and Space Engineering, Universidad Politécnica de Madrid, Madrid 28040, Spain
2. School of Mechanics and Aerospace Engineering, Southwest Jiaotong University, Chengdu 611756, China
Abstract

The prediction of hydrodynamic performance and acoustics is essential for designing the low-noise tidal turbines that are environmentally friendly to marine life. The blade-resolved simulation was conducted to investigate the performance over tip speed ratios (TSRs) ranging from 4.5 to 8, with particular attention to tower-induced effects. The geometry can be mainly defined by a rotor diameter of D=18 m, a tower height of 1D and diameter of 0.11D, and an axial spacing of 0.33D between the tower centreline and the rotor plane. The rotor motion was resolved using a sliding-mesh approach, and the k-ꞷ SST turbulence model was adopted to predict the hydrodynamic loads and wake evolution. The turbine achieved a maximum power coefficient (CP) of 0.434 at TSR=5, corresponding to a thrust coefficient (CT) of 0.727. The tower had a limited influence on the overall turbine performance, with the periodic variation of CP remaining within 3% of its mean value and that of CT within 2%. However, the single-blade performance decreased obviously near the tower. As TSR increased, the tower-induced reductions in both CP and CT became more pronounced, and the phase of the minimum coefficients shifted gradually earlier. Specifically, the CP normalized by its mean value at TSR=8 varied from 89% to 104% over one revolution, while the normalized CT varied from 95% to 102%. The minimum CP occurred approximately 8° ahead of the minimum CT for the studied cases. The acoustics was primarily estimated using the broadband noise source model. The results indicated that the integral value of surface acoustic power over the rotor increases approximately linearly with the TSR and reached 80.96 dB re 1 pW at TSR=8, which is 11.88 dB higher than that at TSR=4.5. These findings can provide preliminary guidance for balancing noise reduction and power generation efficiency.

Keywords
full-scale
tidal turbine
acoustics
tip speed ratio
Outrigger Diameter and Separation Effects on Roll, Heave, and Stability of Philippine Fishing Vessels in Beam Seas
Estimating Human Failure Rates for the Reliability Comparison of Manned and Unmanned Vessels