EventsThe 2nd International Online Conference on Marine Science and Engineering
Published
This submission belongs to the session S2. Coastal Engineering of the event The 2nd International Online Conference on Marine Science and Engineering
Published date
18 Nov, 2026
Academic Editor
author-avatarMaría Isabel Lamas Galdo
Citation
Yolane Abid, Armelle Jarno, Ahmed Benamar, François Marin, The influence of the sediment bed disposition on the bedload threshold motion using the image correlation method., in Proceedings of The 2nd International Online Conference on Marine Science and Engineering, 23 November–25 November 2026, MDPI: Basel, Switzerland
Share
Email
Facebook
Twitter
LinkedIn

The influence of the sediment bed disposition on the bedload threshold motion using the image correlation method.

image
image
1. UFR Sciences, Le Havre Normandie University, Le Havre 76 600, France
Abstract

Since Shields 1936, various experimental methods have been developed to determine this threshold for the transport of homogeneous and heterogeneous sediments. More recently, the correlation method (Vah et al. 2022)—a non-intrusive optical method—has enabled the detection of a kinematic threshold preceding stochastic transport on an acceleration ramp of 1.3 x 10-3 m.s-2. This technique provides a highly sensitive and objective measurement compared to traditional techniques.

From an experimental standpoint, determining the bedload threshold almost always involves flume tests. Different researchers arrange their sediment beds in one of two ways: either above a double bottom or in a pit. In the literature, there are no studies comparing the thresholds obtained for these two configurations. The objective is therefore to determine whether the arrangement of the sediments influences the value of the bedload threshold using the image correlation method.

The bedload threshold for medium-grained sand (D50 = 328 µm) was studied in a recirculating flume named CH1, which is 13.0 m long and 0.49 m wide. The sand was placed in two configurations: above the double bottom (CH1a) and in the pit (CH1b). In CH1a, the sand layer is δ = 0.02 m thick and extends 2 m in length. In CH1b, the pit is 1.0 m long and δ = 0.12 m thick. The slopes of the pit are vertical. The beds are located in a fully flow developed area. Furthermore, the flume slope was kept at zero and constant.

Results show that bedload thresholds detected with CH1a and CH1b configurations are identical (Ubl,c = 0.313±0.006 m.s-1 and u*bl,c = 0.010±0.001 m.s-1 for CH1a and Ubl,c = 0.303±0.016 m.s-1 and u*bl,c = 0.010±0.001 m.s-1 for CH1b (u* : critical friction velocity)).

Keywords
sediment transport
flume experiments
image analysis
bedload transport,
A Numerical Framework for Investigating Coastal Erosion and Sediment Transport
Satellite-Based Assessment of Coastal Hydrological Disturbance, Flooding and Waterlogging on the Kinburn Peninsula after the Kakhovka Dam Destruction