Previous studies in the Agujero Azul (South Atlantic, Argentina) revealed a size overlap between anthropogenic particles (APs) and plankton, increasing ingestion and trophic transfer probabilities. This study evaluated the ecological risk of APs using the Pollution Load Index (PLI), Polymer Hazard Index (PHI), and Integrated Ecological Risk Index (ERI) across the mixed (5 m), epipelagic (5–200 m), and mesopelagic (>200 m) layers. Micro-FTIR analysis (n=142) identified cellulosic (64.1%), synthetic (32.4%), and inorganic (3.5%) particles. Polyester dominated synthetic particles (58.7%), followed by ethylene-vinyl acetate (13%) and polyurethane (10.8%). Polyethylene, polypropylene, polystyrene, polyacrylonitrile, and polyvinyl chloride each accounted for <10%. Lacking regional standards, PLI was calculated using the average concentrations from this study as a reference level. PLI values were low across mixed (0.86), epipelagic (0.89), and mesopelagic (0.73) layers. Risk indices focused exclusively on pure synthetic plastics. The dominant cellulosic fraction (considered primarily of anthropogenic/regenerated origin) was excluded because no hazard score is available for this material, though this does not imply it is harmless. The PHI indicated critical hazard (Category V) in the mixed (2,667.88) and mesopelagic (2,396.51) layers due to polyurethane and polyacrylonitrile, but low hazard (Category I; 5.00) in the epipelagic layer. The ERI indicated low integrated ecological risk across all strata (77.20, 3.26, and 56.64, respectively). Overall, AP loads varied around the local mean and integrated risk remained low. Although these indices were designed for sediments and may not fully capture water-column dynamics (transport, dilution, vertical transfer, bioavailability), the presence of hazardous polymers underscores the importance of identifying the composition of APs.