Sequential Analytical Solutions (SAS) has been developed for simulation of water quality parameters in rivers and estuaries by solving the exact analytical equations for stretch of river with multiple point sources discharging wastewater. The technique used for SAS involves an intelligent use of solving exact analytical solutions in form of N x N matrix with a set of linear algebra equation. Genetic Algorithm ( GA) is used for optimization of water supply and ground water modelling since 1980s. But in this study GA is used for parameterization of SAS for WQM ( Water Quality Modelling. Results of the two initial tests conducted showed the suitability of GA as a calibration technique. In both cases GA estimated the rate constants accurately. The parameter estimation of a model based on analytical solution is usually a complex process. GA works on the fitness function. The derivative or continuity condition, therefore, does not affect the convergence of GA. In the present study as SAS are strictly following the sequence of real field reactions, which actually takes place during DO-BOD coupled reaction when BOD is exerted by carbonaceous compounds followed by nitrogenous compounds, GA also estimate the rate constants following same sequence. The encouraging results of a full-fledged real field case study for river Hooghly, India shows that application of GA as a calibration tool for SAS saves cost and time required for logistic arrangement in actual sampling and analysis to a great extent. A river stretch of 50 km was considered with about 150 outfalls. Different GA operator sets are selected and GA-SAS is run 500 times. The GA usually converged within 35 generations with cross over probability 0.8 and mutation probability 0.06 in most cases. The rate constants estimated by GA agree very well with the rate constants actually observed through laboratory analysis for five locations. GA is found to be very useful for estimations of the rate constants for simulation of water quality in estuary