A detrimental effect on the environment and humans, including animal health due to heavy metals releasing from industrial activity and electroplating industry. To address these heavy metals contamination an efficient adsorbent is required to solve the problem. Herein, we used an agro waste product as the source starting material to prepare a polymer adsorbent. Thus, we extracted cellulose from waste products, and it was utilized to prepare a copolymer via a free radical polymerization. Father, this lower--cost cellulosic precursor is used to synthesize a poly(amidoxime) ligand for heavy-metal removal from wastewater. FT-IR spectroscopic analysis was applied to identify the cellulose, polyacrylonitrile-grafted cellulose, and poly(amidoxime) product. Other spectroscopic analyses were performed for characterization of the products. Herein, a series of batch adsorption process was performed to find out the performance of metal adsorption with the material toward Cu²⁺, Fe²⁺, Ni²⁺, Co²⁺ and Zn²⁺ ions under varying pH levels and contact times. The adsorption capacities were excellent, likely, copper ions adsorption is higher than other metal ions, however, iron, cobalt, nickel and zinc ions showed good adsorption behavior. It was observed that metal ions adsorption capacities were pH dependent as such the following order, pH 6 > pH 5 > pH > 4 > pH 3. Freundlich isotherm study reveals that a multilayer adsorption occurred with a very good correlation coefficient (R² > 0.99). The adsorption kinetics followed a pseudo-first-order model (R² > 0.99). In addition, electroplating wastewater was applied to find the feasibility of metal removal by the cellulose-based adsorbent, which showed excellent removal, with up to 98% of metals removed from wastewater.