This work presents a lotus-to-rice biomimetic concept for adaptive directional wetting on a single mechanically programmable superhydrophobic coating. Lotus leaves retain an air layer within hierarchical roughness, minimizing solid-liquid contact so that droplets roll off with low resistance and little dependence on direction. Rice leaves, in contrast, combine superhydrophobicity with aligned micro/nanotopography, so droplets preferentially slide along the vein direction. Reproducing only static lotus-like mobility or only fixed rice-leaf-like anisotropy limits the use of such surfaces in open microfluidics and adaptive water management. Here, we use strain-programmable porous wrinkles to translate these two plant strategies into a switchable routing surface, where mechanical strain modulates wrinkle geometry and therefore the preferred droplet trajectory.
The surface was prepared by electrospraying 3-6 um polycaprolactone microparticles, transferring the particulate layer to a pre-strained acrylic elastomer, and releasing the pre-strain to form aligned microscale wrinkles. A 25 um particulate layer and 300% pre-strain were used to generate robust wrinkle topographies for subsequent tests. CF4 plasma fluorination lowered the surface energy, while the interconnected submicron void network within the particle/fiber assembly preserved trapped air and resisted liquid penetration. Wrinkle period, apparent wettability, sliding behavior, and droplet trajectories were characterized as tensile strain was varied from the relaxed state to 150%. The period of the microwrinkles was measured from multiple wrinkle locations, and droplet mobility was evaluated using 10 uL water droplets and tilted-stage tests. To directly demonstrate rice-leaf-like anisotropic routing, a 60 s fluorinated sample was rotated 30 deg about the z-axis and tilted 4.7 deg along the x-axis. Continuously dispensed droplets were then observed as the tensile strain was changed, allowing the same surface to be compared under gravity-dominated and wrinkle-guided transport conditions.
The wrinkle geometry responded strongly to in-plane strain. For substrates prepared with 300% pre-strain, the average wrinkle period increased from approximately 55 um without tensile strain to approximately 140 um at 150% tensile strain, while the wrinkle amplitude decreased. This change in ridge spacing and depth altered contact-line resistance without eliminating the non-wetting character of the porous coating. Fluorination brought the surface into the superhydrophobic regime; at suitable treatment conditions, the coating maintained high apparent contact angle while strain primarily changed flow resistance rather than causing persistent wetting. In the directional-routing test, droplets on the 150% strained surface slid close to the gravity direction, indicating comparatively isotropic flow resistance and lotus-like mobile roll-off. When tensile strain was reduced, the wrinkle period decreased and the aligned texture imposed stronger anisotropic resistance. Under these conditions, droplets moved preferentially along the wrinkle direction, and the measured angle between the wrinkle direction and the sliding trajectory was approximately 10 deg. This quantitative trajectory shift supports the poster's mechanistic statement that wrinkle anisotropy tunes pinning and redirects droplet motion. No obvious droplet residue was observed during the trajectory-switching process, supporting the role of the submicron void network in maintaining air-supported superhydrophobicity.
This abstract focuses on directional flow control, distinct from droplet pickup or splitting. The central mechanism is that strain-tuned wrinkle anisotropy changes contact-line pinning: stretched wrinkles allow droplets to follow gravity more readily, whereas relaxed wrinkles provide rice-leaf-like guidance along the aligned ridges. The result is a mechanically reconfigurable, residue-resistant superhydrophobic surface that can convert lotus-like roll-off into rice-leaf-guided sliding without changing the chemical pattern of the surface. Compared with fixed anisotropic textures, this approach uses mechanical deformation to tune droplet paths after fabrication. Such adaptive directional transport may be useful for open-surface microfluidic routing, water collection, self-cleaning tracks, and lab-on-surface systems in which droplet paths must be adjusted during operation.