Inchworm-inspired soft robots generate Ω-shaped crawling through alternating end anchoring and whole-body bending, providing a simple locomotion strategy for confined spaces. Since the entire body deforms during each cycle, crawling performance may change with robot size. This study investigates the influence of body size on Ω-shaped locomotion of cable-driven soft robots inspired by inchworm locomotion.
The cable-driven soft robot prototypes have body lengths of 145 and 235 mm, respectively, and a laterally symmetric silicone body with slots on one surface to guide bending in a prescribed direction. Three motor-driven cables sequentially bend the head, abdominal, and tail sections, while nano-adhesive pads at the two ends provide the substrate adhesion required for motion. Cable retraction bends the body into an Ω shape, and cable release allows it to recover, producing forward locomotion. A programmable control board activates the three DC motors in a preset sequence to ensure repeatable crawling cycles.
The robots were first tested on a horizontal surface at the same motor speed and winding-drum diameter, thereby yielding the same cable retraction speed. Despite their difference in body length, both robots achieved an absolute crawling speed of approximately 1.43 mm/s. Using displacement per second per unit body length as the performance measure, the smaller robot achieved a body-length-normalised speed approximately 1.63 times that of the larger robot.
To produce a comparable Ω-shaped deformation, the larger robot must retract a longer length of cable. This increases the distance travelled during each cycle but also extends the cycle time, leaving the absolute crawling speed almost unchanged. An equal increase in cable retraction speed should produce similar absolute-speed increases in both robots, but a larger increase per unit body length in the smaller robot. The predicted increase for the smaller robot is therefore 1.62 times that for the larger robot, matching the ratio of the larger body length to the smaller one. Changing the winding-drum diameter allowed this relationship to be tested experimentally, giving a measured ratio of 1.63.
When cable retraction speed is limited, smaller robots using this actuation strategy therefore have an advantage in achieving rapid body-relative motion through an Ω-shaped gait. This result provides a basis for matching robot size to actuation capacity in cable-driven soft crawlers intended for pipe inspection and other confined environments.