EventsThe 3rd International Online Conference on Biomimetics
Published
This submission belongs to the session S2. Biomimetic Materials—Structures, Surfaces and Interfaces of the event The 3rd International Online Conference on Biomimetics
Published date
19 Nov, 2026
Academic Editor
author-avatarXu Hou
Contribution&Funding
Conceptualization,
[Alexander Gerasimenko]
Methodology,
[Mikhail S. Savelyev] ; [Kurilova Ulyana] ; [Alexander Gerasimenko]
Formal analysis,
[Victoria Suchkova]
Investigation,
[Kristina Efremova] ; [Evgenia Kuznetsova] ; [Kurilova Ulyana] ; [Ekaterina Otsupko] ; [Victoria Suchkova]
Writing - original draft,
[Mikhail S. Savelyev] ; [Ekaterina Otsupko]
Supervision,
[Denis Murashko]
Funding: This work was supported by the Ministry of Science and Higher Education of the Russian Federation (project FSMR-2024-0003)
Citation
Mikhail S. Savelyev, Kristina Efremova, Evgenia Kuznetsova, Kurilova Ulyana, Denis Murashko, Ekaterina Otsupko, Victoria Suchkova, Alexander Gerasimenko, Photocurable carbon-containing hydrogels for neural interfaces: laser-induced formation and characterization, in Proceedings of The 3rd International Online Conference on Biomimetics, 24 November–26 November 2026, MDPI: Basel, Switzerland
Share
Email
Facebook
Twitter
LinkedIn

Photocurable carbon-containing hydrogels for neural interfaces: laser-induced formation and characterization

Evgenia Kuznetsova 2
Denis Murashko 2
Victoria Suchkova 2,3
image
1. Institute of Biomedical Systems, National Research University of Electronic Technology (MIET), Moscow, 124498, Russia
2. Institute of Biomedical Systems, National Research University of Electronic Technology (MIET), Zelenograd, Moscow, 124498, Russia
3. Institute for Bionic Technologies and Engineering, I. M. Sechenov First Moscow State Medical University (Sechenov University), Moscow, 119991, Russia
Abstract

Introduction

The increasing prevalence of nervous system disorders is driving the development of implantable microelectronic devices for both diagnostics and therapy. The compatibility of neural interfaces with neural tissue, the quality of bioelectrical signal recording, and the efficacy of electrical stimulation are largely governed by their surface properties. A promising strategy involves the use of composites based on carbon nanomaterials, namely nanotubes and graphene. Their characteristic dimensions (down to 10 nm) are comparable to those of neuronal processes—dendrites and axons. The structural similarity of carbon nanotubes to action-potential-conducting axons, and of graphene sheets to postsynaptic membranes mediating chemical synaptic transmission, ensures intimate contact without substantially disrupting the native tissue architecture.

Methods

Laser-induced photocuring and nonlinear optical Z-scan measurements (1 mm cuvette) were carried out using a laser system (500 mW, 1070 nm, 100 ns, 30 kHz). The liquid dispersion medium consisted of single-walled carbon nanotubes (SWCNTs, 0.031 mg/mL), reduced graphene oxide (0.015 mg/mL), eosin Y (0.3 mg/mL), albumin (46 mg/mL), chitosan (17 mg/mL), and collagen (28 mg/mL). The carbon constituents were dispersed in a 1% aqueous solution of sodium deoxycholate (surfactant), with particle size monitored by dynamic light scattering. The electrical conductivity of the photocured specimens was derived from surface resistance and micrometric thickness measurements. Biocompatibility was evaluated using the Neuro 2A cell line.

Results

A hydrodynamic radius of 230 nm was attained without a significant increase in defect density—half the value obtained in the absence of the surfactant. Ultrasonic treatment further reduced this parameter, leading to an increase in the effective nonlinear absorption cross-section to 1175 GM, a decrease in the threshold exposure to 0.17 J/cm², and a rise in the nonlinear refractive index to 0.15 cm/GW, owing to enhanced self-focusing. Following immersion in phosphate-buffered saline, the electrical conductivity changed from 11 to 19 mS/cm. Cells grew individually and were uniformly distributed across the surface, confirming biocompatibility.

 

Conclusion

The resulting hydrogel can be formed on surfaces of complex geometry with adequate adhesion, suppresses electrode encapsulation, and enables a functional neural interface.

Funding: This work was supported by the Ministry of Science and Higher Education of the Russian Federation (project FSMR-2024-0003).

Acknowledgments: The work was performed using the equipment of the Shared Use Center "Center for Laser Technologies in Medicine" with the support of the Ministry of Science and Higher Education of the Russian Federation (Agreement No. 075-15-2025-669 dated August 5, 2025). The authors express their profound gratitude to their colleagues who assisted in the biocompatibility assessment of the photocured hydrogels: Irina Aleksandrovna Suetina and Marina Vladimirovna Mezentseva.

Keywords
hydrogel
neural interface
electrical conductivity
carbon nanotubes
reduced graphene oxide
hydrodynamic radius
Development of a Fungal-Derived Chitosan-Aloe vera Hydrogel with Antibacterial Potential for Topical Burn Wound Healing Applications
Preparation of biomimetic doxorubicin delivery systems based on extracellular vesicles and cell membranes